StudentShare
Contact Us
Sign In / Sign Up for FREE
Search
Go to advanced search...
Free

VMC in Aircraft Issues - Essay Example

Cite this document
Summary
The essay "VMC in Aircraft Issues" focuses on VMC, an airspeed at which a plane remains in control and operational when an acritical engine suddenly becomes inactive. The optimal airspeed enables a pilot to control the movement of the airplane, and maintain a straight flight at a speed of movement. …
Download full paper File format: .doc, available for editing
GRAB THE BEST PAPER95% of users find it useful
VMC in Aircraft Issues
Read Text Preview

Extract of sample "VMC in Aircraft Issues"

VMC IN AIRCRAFT Instruction Introduction VMC is the airspeed at which a plane remains in control and operational when acritical engine suddenly becomes inactive. The optimal airspeed enables a pilot to control the movement of the airplane, and maintain a straight flight at the speed of movement similar to when both engines are present. It is also defined categorically as the speed designed by the airplane manufacturer under the set standards and certification criterion that a plane can operate on one engine only while still the pilot maintains control of the plane. That is it is the technique to gain control of a flying aircraft even in circumstances when one engine collapses. It corrects the destabilization and possible accident that may occur when one engine of a plane collapses or fails when flying. According to Gudmundsson (2014), a plane loses over 80% of the existing thrust levels when operating with two engines. The loss may cause huge damage unless critical response modalities are undertaken first hand to change and reconfigure the pitch attitude and drag predicament of the aircraft. When one engine cools off, the airspeed signal or indicator will move towards the red redial line that is located at the lower end of AS1. The redial indicator shows the VMC level at the point in time. If the red light indicates or moves to the 80-MPH mark on the AS1 then danger looms, as the unthinkable is prone to happen despite the full thrush that is produced by the functioning engine. The method used to simulate critical engine failure As noted, the most critical moments that the airplanes engines are imperative are during takeoff or a few seconds after takeoff. During this time, the airspeed is at its lowest prompting the engines to develop maximum rated horsepower. The power is to guarantee speed and security of the plane and ensure that any fault is not recorded (Gudmundsson, 2014). If the engine quits or becomes dormant at the stage then the pilot has two options 1. The plane can proceed with the departure climb that will facilitate the asymmetric thrust from the single operating engine. This will cause the airplane to flip on its back effectively at a bank range of 5 degrees that is favorable. 2. The departure of the aircraft can be continued and climb on a single engine especially when the speed is sufficiently fast (Gudmundsson, 2014). The degree level of bank is a key determinant of VMC as it causes either increase or decrease in the VMC level or the speed of operation of the plane. 2 to 5 degree level is recommended for favorable VMC as compared to degree levels beyond 5 as such arrange may cause serious complication. Therefore, the bank degree range of between 2 to 5 degrees causes VMC to decrease when the redial line is at 80-MPH. The bank degree levels above 5 increases VMC to higher levels in most instances. Maximum available takeoff power initially on each engine Sxxxx indicated, a few seconds after an aircraft’s takeoff under the maximum available power presents grave challenges that may results to collateral damage if not managed well. It is the time when one engine can go off or become inactive thereby exposing the plane to danger of crashing. During takeoffs under maximum conditions, the main goal of pilots is to get at a Vyse (105MPH) faster and ensure that the speed is maintained until possible risks relating to engine failures are mitigated (Gudmundsson, 2014). During takeoff of aircrafts when maximum initial power is on each engine, proper monitoring of their performance is necessary to establish any emergency in prior. Proper assessment and response to emerging complications are also necessary. The pilot should always monitor the ASI and red radial line to establish whether it is at the right and sustainable rate. This is imperative in determining detrimental nature of the danger that is posed. Takeoff or departure time of aircrafts affects the vmc level of aircrafts given that the possibility of an engine failure is high at this stage. When one engine fails at stage, the VMC will decrease. However, the aircraft will still be able to gain the reasonable power and thrust for survival that is normally stands at 80MPH. The marginal success range for aircrafts is when the Vyse stands at 80 to 105MPH. Any value of Vyes above the favorable figure causes immense danger that includes death. The airplane trimmed for takeoff Certification within 5 degrees It is true that the degree of bank that I present in the operating engine affects in greater way the VMC conditions. This is evident since the recommended limit of the VM degree of bank allowed is up to 5 degrees. The FAA body that regulates the operations, certifies that aircraft manufacturers should ensure that the VMC of the planes they produce is limited to not beyond 5 degrees. The degree range provides the safest position upon which the VMC of the plane remains favorable even when an aircraft faces one engine failure (Gudmundsson, 2014). For instance, when the degree is at 2 degrees or within 5 degrees of bank in the operating, then the lift component will aid rudder thereby reducing the VMC force. Therefore, at 2 degrees position, the VMC will be reduced to favorable levels during engine failure and higher level when beyond five degrees. The heavier the plane, the lower the VMC under the conditions and vice versa. At maximum, takeoff weight During takeoff of aircrafts, weight is highly significant within the fine degrees of bank degrees to the HCL whose generation takes place when the plane establishes. HCL increases as weight increases because of the advancement in AOA force within 5 degrees limit of the bank. The force that occurs the operational engine reduces the rudder necessary for systematic counteracting of inertia including yellow tendencies. Under such circumstances, an objection in motion regardless of the gravity will stay in motion unless another force acts upon them (Gudmundsson, 2014). Therefore, it is difficult for a heavier plane to be affected with the increase in HCL and loss direction of control and VMC. On the hand, it is recognizable that VMC will always increase because of a P-factor as the weight of the plane and AOA increases thereby moving the thrust cosrr to the tops This condition causes movement complications when the critical engine is dead causing VMC decreases. Flaps in the takeoff position The takeoff flaps position can be up or down based on the size of your plane Indeed, the takeoff flaps influences the VMC state of a plane by either increasing or decreasing the VMC depending on the position of the flaps. Particularly, when the flaps are down, the plane normally increases its performance especially after takeoff, stabilizes on the air that shows assign of safety. The stabilization of the plane and increase in performance thereby facilitates the systematic decrease of VMC. Therefore, VMC of the plane decreases when the flaps are down and increases when the flaps are up. Landing gear retracted The retraction of the landing gear exposes aircrafts to severe danger as it causes acute reduction in the VMC rate. This occurs given that the retraction of the gear increases the planes susceptibility to uncontrollable yaw. This occurs systematically below the VMC thereby causing usability danger. Retraction of the landing gear causes a decrease in VMC while its availability presents an increasing effect on the VMC. Maximum available takeoff power initially for each engine As noted, a certified aircraft by the FAA body favorably operate with its two engines and at the maximum weight within the recommended VMC. The provision of two functional engines, maximum weight, and other aspects should enable the plane to operate at a range of 80 MPH to 105 MPH rate of ASI without experiencing any issue regarding increaser or decrease in VMC. Therefore, where there is maximum available takeoff power under the favorable VS1 as indicated, favorable VMC would be recorded. A plane under such conditions will Airplane trimmed for an approach The landing distance, gradient and steepness of the runway presents immense influence on the VMC rate. Aircrafts that operates with full engines have the capacity to land effectively without any form of challenges especially if the landing distance is within the favorable limits and at an approach gradient, which matches the favorable landing altitude. When the landing distance is long, with deep steepness of the terrain, the VMC level of an aircraft is bound to decrease while a short landing distance and shallow terrains result to increase in VMC. Flaps at landing position Landing of planes requires high level of stability and performance capacity to guarantee safety. When a plane is nearly landing based on the concept of gravitational pull forces and weight, the flaps faces upwards and downwards after landing. Plane with a favorable weight and gravitational pull requires stability as it lands and favorable VMC (Gudmundsson, 2014). When the plane is coming down the flaps will increase the amount of VMC that is to enhance stability and increase safety level However, when the flaps are downwards then the level of VMC decreases effectively. However, when the flaps are up the VMC increases significantly to appoint where control is necessary. The increase in the VMC is facilitated with the reduction of performance levels, stabilization, and control of the plane. The flaps affect the plane after takeoff as they cause greater draw on the remaining thrust in the good engine. They are also not extended to take off much but to the takeoff variations of performance for both short and soft fields. Therefore, the pilot should determine the position of aircrafts take off to avert possible challenges. Extended landing gear Under the conditions presented or when an aircrafts weight is less than the maximum point, extension of the landing presents limited danger. The extension is necessary in cushioning the plane from the susceptibility rate of the uncontrollable yaw. That is the extension enables planes to become controllable within the recommended VMC rate and favorable ASI. All propeller controls in the recommended takeoff position throughout The position of the propellers of a plane affects VMC capacity by either increasing or decreasing in AS1. This in turn affects the movement of planes and exposes them to real danger especially when one engine becomes in effective (Gudmundsson, 2014). When the propellers are ij the recommended position and other factors such as the weight of the plane remains constant, the level or rate of VMC would be favorable. The rate would increase within the recommended limits and facilitate stability and movement of the plane even when one engine records some element of failure. The VMC rate increases when the propeller control during takeoff position is in operation and reduces when the control is fairly in operation. References Gudmundsson, S. (2014). General aviation aircraft design: Applied methods and procedures. Oxford: Butterworth-Heinemann. Read More
Cite this document
  • APA
  • MLA
  • CHICAGO
(“Aerodynamics Essay Example | Topics and Well Written Essays - 1500 words”, n.d.)
Aerodynamics Essay Example | Topics and Well Written Essays - 1500 words. Retrieved from https://studentshare.org/miscellaneous/1688010-aerodynamics
(Aerodynamics Essay Example | Topics and Well Written Essays - 1500 Words)
Aerodynamics Essay Example | Topics and Well Written Essays - 1500 Words. https://studentshare.org/miscellaneous/1688010-aerodynamics.
“Aerodynamics Essay Example | Topics and Well Written Essays - 1500 Words”, n.d. https://studentshare.org/miscellaneous/1688010-aerodynamics.
  • Cited: 0 times

CHECK THESE SAMPLES OF VMC in Aircraft Issues

Technology in Aircraft Maintenance

This essay describes the avionic industry as a whole and especially, technology in aircraft maintenance that has also grown significantly since the last few decades.... Technologies in aircraft maintenance systems for commercial aviation have significant progress since the beginning of simple BIT tests in the early 1980s.... The researcher describes the performance of the advanced system that is main focus of the essay that intervenes and collect data from all assemblies of aircraft equipment to make sure that all systems of aircraft are functioning properly, and if in case any fault that will be indicated at the front panel in the cockpit....
6 Pages (1500 words) Essay

Technology Essential for Aircraft Maintenance

As explained earlier technology in aircraft maintenance systems for commercial aviation has undergone major development since the beginning of simple BIT tests in the early 1980s.... The aim of the plan is to ensure the sustained airworthiness of the commercial aircraft through upgrading equipment, techniques, practices, and procedures in aircraft and engine design, repair, maintenance, and inspection (DTIC, 1991).... To understand the response of materials for long time exposure in aircraft structures service conditions, a basic knowledge of the physical occurrence related to damage and failure has to be developed....
6 Pages (1500 words) Essay

Airline Maintenance Program in the United States

For this purpose, airlines are constantly working with aircraft firms to enhance security and performance.... The maintenance program of an airline specifies the period at which aircraft and engine parts to be serviced and inspected.... Reports of maintenance details on an aircraft are to be kept and made available for FAA appraisal.... The repair and maintenance plan involves a number of multifaceted inspection and maintenance procedures, basing on an aircraft flying hours, number of landings and takeoffs....
10 Pages (2500 words) Literature review

Life Cycle Analysis of Aircraft Environmental Control Systems

The paper "Life Cycle Analysis of aircraft Environmental Control Systems" focuses on the systems that maintenance planners can use to estimate performance/inspection scheduling/cost early in the design and selection phase for this important subsystem.... Life cycle analysis of the environmental control systems (ECS) is a significant part of the aircraft functioning during flights.... In this respect a particular analysis of ECS in terms of design and manufacture, installation on the aircraft, removal for repair at the depot level, and complete replacement from the manufacturer....
6 Pages (1500 words) Essay

Singapore Airlines Flight 006

Since the first aircraft was invented, a lot has been witnessed in the field of aviation that has seen the number of accidents reduce to a manageable level.... However, aircraft accidents occurring due to human errors and other common mistakes are still being witnesses within the aviation industry.... he Boeing 747-400 aircraft started off from the airport having been cleared for departure on runway 05L.... However, the aircraft took deviated from the right turn entering a wrong runway (05R) which had been closed for purposes of repairer....
7 Pages (1750 words) Report

Saving in Aircraft Maintenance Cost

The writer of the paper 'Saving in aircraft Maintenance Cost' states that the airline company can reduce the direct maintenance cost of the aircraft in a trouble-free manner.... The business vision and mission of the company, as well as the nature of the aircraft, determines the strategy that the company will acquire for maintenance of the aircraft.... Every airline needs to maintain aircraft as it is imperative for operating safer flights....
23 Pages (5750 words) Report

Moorabbin Airport Midair Collision between UPY and CGT Aircrafts on 27th August 2008

This paper "Moorabbin Airport Midair Collision between UPY and CGT aircraft on 27th August 2008" provides an extensive analysis of the mid-air collision between the UPY and CGT that occurred on 27 August 2008 3km away North-West of Moorabbin Aerodrome, Victoria.... The cause of the aviation accident observed in the paper was mainly due to human factors including poor situational awareness of the solo pilot in the UPY aircraft, work overload of the air traffic controller, lack of situational awareness of student pilots bin either aircraft, poor visual acquisition, and poor separation of traffic flows at the aerodrome....
12 Pages (3000 words) Case Study

Characterization of an Airworthiness

The main challenges that the modifications present to the company are well covered herein with the solutions that are going to aid in solving the principle issues.... This paper outlines some of the issues identified as key to the technical airworthiness of these aircraft and how the company intends to manage this kind of issue.... This shall be carried out together with the minimum issues associated with the initial certification which is associated with the base aircraft and the modifications that shall be carried out for firefighting....
13 Pages (3250 words) Coursework
sponsored ads
We use cookies to create the best experience for you. Keep on browsing if you are OK with that, or find out how to manage cookies.
Contact Us